HARLEY DAVIDSON FRONT TURN SIGNAL RELOCATION KIT REMOVAL AND INSTALLATION MANUAL

download
REMOVAL When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) 1. Purge the high-pressure fuel line and disconnect the fuel line following the instructions in the appropriate Service Manual. To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b) 2. Remove the main fuse following the instructions in the appropriate Service Manual. 3. Remove the seat following the instructions in the appropriate Service Manual. Save all seat mounting hardware. NOTE When moving the fuel tank back, do not damage the fuel gauge wires clipped to the frame under the left side of the fuel tank. 4. Remove the front and rear fuel tank mounting hardware following the instructions in the appropriate Service Manual. Move the fuel tank back on the frame to gain access to the tabs on the steering head harness shield. 5. See Figure 1. Disengage the tabs (2) from the holes (3) on each side of the frame and remove the shield (1). 6. Pull the wire harness down from inside the frame enough to disconnect the white (left) [31L] and black (right) [31R] 3-place turn signal connectors. Set aside the frame-side connector halves. 7. Remove the socket terminals from the lamp-side connector halves following the instructions in the appropriate Service Manual. Make note of the wire colors installed in the cavities of each connector, which should be: Left side (white connector): a. Black [BK] wire in cavity 1 b. Violet [V] wire in cavity 2 c. Blue [BE] wire (if installed) in cavity 3 Right side (black connector): a. Black [BK] wire in cavity 1 b. Brown [BN] wire in cavity 2 c. Blue wire [BE] (if installed) in cavity